The PANIC Button

Ok, bit of explanation first.  We have an iMac set up as a 'democratic jukebox' at HAC:Manchester.  The idea being that anyone can put music on it, and it plays the entire library on shuffle during our hack sessions for a bit of background music.

The problem is, of course, some people have an... odd taste in music, so sometimes the jukebox ends up flipping between Aqua and Cannibal Corpse for ten minutes, and the horror of this was just too much!

Enter the PANIC button.

 

The button uses a minimus board. The minimus is a carrier for the AT90USB162, an AVR microcontroller with onboard USB hardware, which means it can be programmed to show up as any USB device.  Before getting the button I modified one of the pieces of LUFA demo software, a media keyboard, and stripped it down to just read the one button on the minimus.  When the button is pressed, it sends the keycode for next track. 

The button's housing is a joke button that played an alarm and flashed when pressed, I ripped its guts out to get to the switch.  After finding the switch contacts on the original board, i soldered on two wires to connecto to the AVR.

Next,  I stripped off the USB connector  from the minimus, and added a 1m USB lead directly to the pads, to make it fit in the old speaker housing section of the button.  I connected the leads from the button to PD7 and GND on the minimus, the same as the onboard button.  This has the handy side effect that if the button is pressed while being plugged in, it boots into DFU mode, allowing me to upgrade the firmware easily.

I cut a slot in the casing for the wire to escape, and added a couple of cable ties for strain relief.

Press Button, Song Skips, Panic averted!

 [Download Code] - AVR C

thinkl33t

thinkl33t wrote 21 posts

Post navigation